Join two grids along their common edge
gmt grdpaste file_a.nc file_b.nc -Goutfile.nc [ -V[level] ] [ -fflags ] [ --PAR=value ]
Note: No space is allowed between the option flag and the associated arguments.
grdpaste will combine file_a.nc and file_b.nc into outfile.nc by pasting them together along their common edge. Files file_a.nc and file_b.nc must have the same dx, dy and have one edge in common. If in doubt, check with grdinfo and use grdcut and/or grdsample if necessary to prepare the edge joint. Note: For geographical grids, you may have to use -f to handle periodic longitudes unless the input grids are properly recognized as such via their meta-data.
One of two files to be pasted together.
The other of two files to be pasted together.
The name for the combined output.
- -V[level] (more …)
Select verbosity level [w].
- -f[i|o]colinfo (more …)
Specify data types of input and/or output columns.
- -^ or just -
Print a short message about the syntax of the command, then exit (NOTE: on Windows just use -).
- -+ or just +
Print an extensive usage (help) message, including the explanation of any module-specific option (but not the GMT common options), then exit.
- -? or no arguments
Print a complete usage (help) message, including the explanation of all options, then exit.
Temporarily override a GMT default setting; repeatable. See gmt.conf for parameters.
Grid File Formats¶
By default GMT writes out grid as single precision floats in a COARDS-complaint netCDF file format. However, GMT is able to produce grid files in many other commonly used grid file formats and also facilitates so called “packing” of grids, writing out floating point data as 1- or 2-byte integers. (more …)
Note: Below are some examples of valid syntax for this module.
The examples that use remote files (file names starting with
can be cut and pasted into your terminal for testing.
Other commands requiring input files are just dummy examples of the types
of uses that are common but cannot be run verbatim as written.
Suppose file_a.nc is 150E - 180E and 0 - 30N, and file_b.nc is 150E - 180E, -30S - 0, then you can make outfile.nc which will be 150 - 180 and -30S - 30N by:
gmt grdpaste file_a.nc file_b.nc -Goutfile.nc -V -fg